Based in Leesburg, VA

Well Pump Installation in Leesburg, VA

Well pump installation in Leesburg, VA for submersible and jet pumps, pressure tanks and controls on private wells.

Request an estimate

Tell us what you need

Water From Your Own Well, Delivered Reliably

Brick Street handles well pump installation in Leesburg, VA and the rural parts of Loudoun County, replacing failed submersible and jet pumps, installing new systems and repairing the pressure tanks and switches that keep water flowing to the faucets. When a well pump quits, the whole house loses water, so our licensed plumbers take those calls 24/7 with no overtime fees. We size the pump to the well depth and the household's needs, not just to the nameplate on the old one. Call (240) 969-4911 if your taps have gone dry.

Plenty of homes outside the town limits, from western Loudoun farms to properties around Purcellville and Lovettsville, draw their water from a private well instead of a public system. That means the owner is responsible for the pump, the pressure tank, the wiring and the water quality. Well systems are simple in principle and unforgiving in practice: a failed pressure switch or a waterlogged tank can burn out a good pump. We also install the water treatment that often goes with a well, including water softeners and whole-house filtration.

Submersible or Jet Pump?

Which one you need depends mostly on how deep the water sits.

Submersible pumps

Sealed pumps that sit down in the well and push water up. They suit deeper wells, run quietly and are the most common choice for drilled wells.

Shallow-well jet pumps

Mounted above ground, often in a basement or well house, pulling water up by suction. They work only where the water level is fairly shallow.

Convertible jet pumps

Jet pumps set up to reach somewhat deeper water. They are easier to service than a submersible because the motor stays above ground.

Pressure tanks and switches

The tank stores pressurized water so the pump does not start every time a faucet opens. A failing tank or switch shortens pump life fast.

Control boxes and wiring

Many submersible systems use an above-ground control box with a capacitor and relay. A failed part there can stop a healthy pump cold.

WARNING SIGNS

When a Well Pump Is on Its Way Out

Sputtering faucets and spurts of air usually mean the water level has dropped near the pump intake or there is a leak in the drop pipe. Pressure that rises and falls with every use, or a pump that clicks on and off rapidly, points to a waterlogged pressure tank or a bad switch. A pump that runs continuously can mean a leak in the system or a pump too worn to reach cutoff pressure. Other clues are dirty or sandy water, a jump in the electric bill with no other explanation, and a breaker that keeps tripping. Catching these early can save the pump. Once a motor has run hot for weeks, repair is rarely worth it.

THE INSTALL

What a Well Pump Replacement Involves

For a submersible pump, the old unit is pulled up with its drop pipe and wiring, then inspected so we understand why it failed. We measure well depth and water level, choose a pump and horsepower that fit the well and the house, and lower the new pump with fresh wire, pipe and a check valve. Up top, the pressure tank gets its air charge set to match the switch, and the switch and controls are tested through several cycles. Any time a well is opened, it is good practice to disinfect it and test the water afterward. We serve Leesburg and many surrounding towns. See our plumbing services for everything else.

No Water at the Tap?

Well pump calls answered 24/7.

Call (240) 969-4911 and a licensed plumber will help get your well running again.

Open now · 24/7

(240) 969-4911

Based in Leesburg, VA.

4.6 from 282 Google reviews

Call now Request an estimate

Frequently asked questions

How do I know if my well pump is bad or it is the pressure tank?

A failing pressure tank causes the pump to short-cycle, clicking on and off every few seconds while water runs, and pressure swings up and down. Tap the tank: a waterlogged tank sounds solid all the way up. A failing pump tends to show low or no pressure, constant running or spurting air. Check the breaker first, then call us to test the system before replacing anything.

What should I check if my well stops producing water?

Start at the breaker or fuse for the pump and reset it once. Look at the pressure gauge on the tank and the pressure switch, which sometimes sticks open after a power outage. If the breaker trips again or the gauge reads zero with power on, stop resetting it, since that can damage the motor. A technician can test the pump, wiring and switch to find the fault.

Should I pick a submersible or jet pump for my Loudoun County well?

Most drilled wells use a submersible pump, because it can lift water from deep in the well and runs quietly. Jet pumps fit shallow wells or situations where keeping the motor above ground for service matters. The right choice depends on the well depth, the static water level and the flow your household needs. We measure those before recommending a pump.

Do I need water treatment if I have a private well?

Many well owners do. Well water is not treated by a utility, so hardness, iron, sediment or bacteria depend on the aquifer and the condition of the well. Testing tells you what is in it. Based on the results, a water softener, sediment filter or whole-house filtration system can protect fixtures and appliances and improve taste. We install those systems along with well pumps.

Can a well pump be repaired instead of replaced?

Sometimes. A bad pressure switch, a failed control box capacitor, a leaking pipe fitting or a waterlogged tank can all be fixed without touching the pump itself. A submersible pump with a burned-out motor or worn impellers is generally replaced, since pulling it is most of the work. We test the parts above ground first to avoid replacing a pump that is still good.

Tell us about the job

Your name, your number and what needs doing. A person from Brick Street Plumbing Heat & Air gets back to you.

Send the basicsYour name, your number and what needs doing. Three fields, about a minute.
A person gets back to youSomeone from Brick Street calls or texts you within one business day.
We book a time that suits youYou get a time that fits your day, and no obligation until you say go.

Rather talk now?(240) 969-4911Open 24/7, same rate any hour

Request an estimate

Takes about a minute