Based in Leesburg, VA

Furnace Repair in Purcellville, VA

Furnace repair in Purcellville, VA from licensed HVAC technicians, any hour of the day, at the same rate as a weekday visit.

Call or text (240) 969-4911

Request an estimate

Tell us what you need

Getting Heat Back in Western Loudoun

For furnace repair Purcellville, VA homeowners can reach Brick Street Plumbing Heat & Air at any hour, and the visit costs the same at 11pm as it does at noon. Our licensed HVAC technicians find out why the furnace stopped heating, explain the fix in plain terms, and get warm air moving again. Gas, propane, oil-fired or electric, the diagnosis starts the same way: confirm power, fuel and airflow, then work through the ignition and safety controls until the real fault shows up.

Purcellville sits at the western end of Loudoun County, close to the Blue Ridge, and winter nights out here tend to run colder than they do closer to the Beltway. A furnace that limps along in November often quits outright during the first hard freeze. Homes in town and on the rural roads around it vary a lot, from older farmhouses with retrofitted ductwork to newer subdivisions with high-efficiency units in the basement, so we bring parts for a wide range of equipment. Read more about our work across Purcellville.

WARNING SIGNS

When a Purcellville Furnace Is Asking for Help

Most furnaces give a few hints before they stop. Short cycling, where the burners light and shut off within a minute or two, often points to a dirty flame sensor or an overheating heat exchanger caused by a clogged filter. A blower that runs but pushes cool air can mean the igniter has cracked or the gas valve is not opening. Banging at startup usually means delayed ignition, which is worth a call right away. Other signs are quieter: rooms at the far end of the house never warming up, a yellow or flickering flame where it used to be blue, or a burning dust smell that lingers past the first few runs of the season. If your carbon monoxide alarm sounds, leave the house and call for help before anything else. Our furnace repair page goes deeper on each of these.

What We Test on Every Heating Call

A repair visit covers the parts that fail most often, not only the one that looks guilty.

Ignition and Flame Sensing

We check the hot surface igniter, the flame sensor and the gas valve sequence. A sensor coated in residue is one of the most common reasons a furnace lights and then quits.

Airflow and Filters

A choked filter makes the furnace trip its high-limit switch. We look at the filter, the blower wheel and return vents, and can set you up with regular filter replacement.

Venting and Draft

The inducer motor and pressure switch confirm exhaust is leaving the house. Wasp nests, ice and sagging flue pipe can all block that path on rural properties.

Thermostat and Wiring

Dead batteries, loose low-voltage wires or a misconfigured smart thermostat can look exactly like a furnace failure. We rule that out early.

FIX OR REPLACE

Straight Answers on Repair Versus a New Furnace

A failed igniter, capacitor or inducer motor is a routine repair, and on a furnace in decent shape that is almost always the right call. The math changes when the heat exchanger is cracked, the unit has needed several major parts in a short span, or the equipment is old enough that parts are hard to find. In those cases we lay out both options side by side and leave the decision to you. If replacement makes more sense, our team handles furnace installation and sizes the new unit to the house rather than copying the old nameplate. Many Purcellville homes also pair a furnace with a heat pump, so we check the whole system while we are there. You can see the other towns we cover on our service area page.

Cold House in Purcellville Tonight?

Same rate day or night, weekends included.

Call (240) 969-4911 and a licensed HVAC technician will start working out why the heat stopped.

Open now · 24/7

(240) 969-4911

Based in Leesburg, VA.

4.6 from 282 Google reviews

Call now Request an estimate

Frequently asked questions

Why does my furnace turn on and then shut off after a minute?

The most common cause is a dirty flame sensor, which tells the control board the burners never lit, so it shuts the gas off for safety. A clogged air filter can cause a similar pattern by overheating the heat exchanger and tripping the limit switch. Swap the filter first. If the short cycling continues, a technician can clean or replace the sensor and check the limit switch, pressure switch and venting so the real cause gets fixed instead of masked.

Do you repair propane and oil furnaces outside Purcellville town limits?

Yes. Many homes on the rural roads around Purcellville heat with propane or oil rather than natural gas, and our technicians work on all of them. Propane furnaces use different gas valve settings and orifices than natural gas units, and oil burners have their own nozzle, filter and ignition parts. We confirm the fuel type when you call so the technician arrives ready for your equipment.

Is it safe to keep running a furnace that smells like burning?

A light dusty smell during the first few cycles of the season is normal, because dust burns off the heat exchanger. A smell that lingers, gets stronger, or smells like hot plastic or electrical insulation is not normal. Turn the furnace off at the thermostat and call. Overheating motors, melting wire insulation and blocked vents can all produce that smell, and running the system longer can turn a small repair into a larger one.

Can a bad thermostat make it look like the furnace is broken?

Yes, and it happens often. Dead batteries, a tripped breaker for the thermostat circuit, loose wires at the base, or a smart thermostat set to the wrong equipment type can all stop the furnace from getting a call for heat. Before booking, check that the thermostat screen is on and set to heat, and that the setpoint is above room temperature. If the furnace still does not respond, we test both the thermostat and the furnace controls.

How do I know if my furnace needs replacing instead of another repair?

Replacement usually makes sense when the heat exchanger is cracked, when repairs are stacking up season after season, or when replacement parts for the model are no longer easy to get. A single failed part on an otherwise sound furnace is normally worth fixing. We give you the diagnosis, the repair option and the replacement option together, so you can weigh them with all the facts in front of you.

Tell us about the job

Your name, your number and what needs doing. A person from Brick Street Plumbing Heat & Air gets back to you.

Send the basicsYour name, your number and what needs doing. Three fields, about a minute.
A person gets back to youSomeone from Brick Street calls or texts you within one business day.
We book a time that suits youYou get a time that fits your day, and no obligation until you say go.

Rather talk now?(240) 969-4911Open 24/7, same rate any hour

Request an estimate

Takes about a minute